burkert 5470

Burkert Media Filtration

Water is becoming a scarce and valuable resource that affects the environment both when it’s extracted from and returned to nature.

The use of particle media from sand to gravel, reduces the need for chemical addition and therefore makes media filtration an environmentally friendly treatment process.

Whether you are treating raw water or process water or waste water, media filtration is a low maintenance and cost-effective system, both in investment and operation, providing a high level removal rate of suspended solids.

Burkert components support the performance of different water filtration steps.

From sensors, which detect pressure differences, to actuators that start the backwash process you will find all your components at a single source to automate and operate your filtration system with us.

Typical Products used in Media Filtration:

burkert type 8025Insertion Paddle Wheel Flowmeter/Batch controller Type 8025

    • Compact or remote version for DN06 to DN400, PN10
    • Displays both flow rate and volume (with two totalizers)
    • Automatic calibration: TEACH-IN
    • Simulation: all output signals provided without the need for real flow

burkert type 8644Remote Process Actuation Control System AirLINE Type 8644

  • Innovative fieldbus interface
  • Combination of Fieldbus, pilot valves and I/O modules
  • High flexibility
  • Compact design
  • High flow rate

burkert type 2000Pneumatically operated 2/2-way Angle-Seat Valve Type 2000

  • St.St. or red bronze housing with sleeve, clamped or welded connection
  • Externally piloted & operated with single or double–acting piston actuator
  • High flow rate
  • Long service life

burkert type 8323Pressure Transmitter Type 8323

    • Piezoresistive or thin film sensor element
    • Available with flush diaphragm standard or acc. to EHEDG
    • Housing and wetted parts in corrosion-resistant stainless steel
    • Standard signal 4…20 mA for connection to automation-systems
    • Plug for quick installation and service

burkert type 54703/2 and 4/2-way Solenoid Valve for pneumatics Type 5470

  • Compact design in 3/2 and 4/2-way versions
  • Extendable valve block
  • Reduced power consumption
  • Different pneumatic connections available
  • Robust

burkert type 6012Direct-acting 3/2-way lifting armature valve Type 6012

  • Push-over solenoid system AC07
  • Compact design, up to DN 1,6
  • M5, G1/8, G1/4, SFB sub-base version
  • 21mm coil spacing when mounted on manifold

burkert type 8176Ultrasonic Level Transmitter Type 8176

  • Compact for level measurement up to 5 m
  • 4…20 mA/Hart – 2 wires
  • Suitable for solids
  • ATEX approvals

burkert type 8055Full bore magmeter Type 8055

  • Combination of mag flow sensor fitting S054 or S055 and electronics SE56
  • Continuous measurement or Batch Control
  • Version without (S054) or with (S055) flanges
  • For water treatment and general purpose applications

Got questions or ready to buy
Tel: +44 (0) 28 93 362282